Fix off-by-one UART bitrate counter value that will make the RX
sampling and TX sending drift. The impact gets higher as the baudrate
increases and the bitrate counter value gets smaller.
Reconfigure the baudrate to keep 500 kbaud.
Correct a forgotten test in testfw that wasn't updated the last time
frequency was raised in commit
75b028505f0d6dc685d37b84d73ddb9db5ee7ea2 in June 17, 2024.
Add incoming and outgoing CTS (Clear To Send) signals for the FPGA to
let the CH552 and FPGA signal each other that it is OK to send UART
data. The CTS signals indicate "OK to send" if high. If an incoming
CTS signal goes low, the receiver of that signal should immediatly
stop sending UART data.
This removes the possibility to configure the bit rate, data bits and
stop bits at runtime from the API. This reduces the
usage of LCs with ~4%.
It is still possible to configure the core before building.
Update digest of application_fpga.bin.sha256
Silence lint on intentional combinatinal loops
Use better instance names, and a single lint pragma for all macros
Remove unused pointer update signals
Silence lint on wires where not all bits are used
Change fw_app_mode to be an input port to allow access control
Remove redundant, unused wire mem_busy
Add lint pragma to ignore debug register only enabled by a define
Remove clk and reset_n ports from the ROM
Adding note and lint pragma for rom address width
Fix incorrect register widths in uart_core
Assign all 16 bits in LUT config
Silence lint warnings on macro instances
Correct bit extraction for core addresses to be eight bits wide
Correct the bit width of cdi_mem_we wire
Add specific output file for logging lint issues
Correct bit width of tmp_ready to match one bit ready port
