c735c6fdde
- Compare against an expected result and count errors - Exit with the right error code - Lower write_word() to 1 clk cycle instead of two. It only requires one clock cycle to write, otherwise if it is two one have to compensate for it in the tests since we are counting cycles. |
||
|---|---|---|
| .. | ||
| rtl | ||
| tb | ||
| toolruns | ||
| README.md | ||
timer
A simple timer with prescaler.
Introduction
This core implements a simple timer with a prescaler. The prescaler can be used to divide the system clock frequency to yield a specific amount of clock frequency ticks for each timer tick. This allows measurement of time rather than cycles. If for example setting the prescaler to the clock frequency in Hertz, the timer will count seconds.
API
The following addresses define the API for the timer:
ADDR_CTRL: 0x08
CTRL_START_BIT: 0
CTRL_STOP_BIT: 1
ADDR_STATUS: 0x09
STATUS_RUNNING_BIT: 0
ADDR_PRESCALER: 0x0a
ADDR_TIMER: 0x0b
Details
The core consists of the timer_core module (in timer_core.v) and a top level wrapper, timer (in timer.v). The top level wrapper implements the API, while the timer_core implements the timer functionality.
The timer counter and the prescaler counter are both 32 bits. Both the
prescaler and the timer register can be set through the API above,
and should be a non-zero value, the defaults are one. These values
cannot be changed when the timer is running.
Bit zero of the status register shows if the timer is running, one
indicates a running timer.
Start the timer by writing 1 to bit zero of the ctrl register, write
1 to bit one to stop it.
Time elapsed can be calculated using:
time = clock_freq / (prescaler * timer)