Add filesystem code and storage syscalls

Adds syscalls:

- ALLOCATE_AREA
- DEALLOCATE_AREA
- WRITE_DATA
- READ_DATA

and code to access the filesystem and the flash over SPI.

Based on original work by Daniel Jobson <jobson@tillitis.see> for
these files:

- auth_app.[ch]
- flash.[ch]
- spi.[ch]
- partition_table.[ch]
- rng.[ch]
- storage.[ch]

which are used with small changes to integrate with the new syscall
method.

Co-authored-by: Daniel Jobson <jobson@tillitis.se>
Co-authored-by: Mikael Ågren <mikael@tillitis.se>

hw/application_fpga/fw/tk1/flash.h

@@ -0,0 +1,58 @@
+// Copyright (C) 2024 - Tillitis AB
+// SPDX-License-Identifier: GPL-2.0-only
+
+#ifndef TKEY_FLASH_H
+#define TKEY_FLASH_H
+
+#include <stdbool.h>
+#include <stddef.h>
+#include <stdint.h>
+
+#define WRITE_ENABLE 0x06
+#define WRITE_DISABLE 0x04
+
+#define READ_STATUS_REG_1 0x05
+#define READ_STATUS_REG_2 0x35
+#define WRITE_STATUS_REG 0x01
+
+#define PAGE_PROGRAM 0x02
+#define SECTOR_ERASE 0x20
+#define BLOCK_ERASE_32K 0x52
+#define BLOCK_ERASE_64K 0xD8
+#define CHIP_ERASE 0xC7
+
+#define POWER_DOWN 0xB9
+#define READ_DATA 0x03
+#define RELEASE_POWER_DOWN 0xAB
+
+#define READ_MANUFACTURER_ID 0x90
+#define READ_JEDEC_ID 0x9F
+#define READ_UNIQUE_ID 0x4B
+
+#define ENABLE_RESET 0x66
+#define RESET 0x99
+
+#define ADDR_BYTE_3_BIT 16
+#define ADDR_BYTE_2_BIT 8
+#define ADDR_BYTE_1_BIT 0
+
+#define STATUS_REG_BUSY_BIT 0
+#define STATUS_REG_WEL_BIT 1
+
+bool flash_is_busy(void);
+void flash_wait_busy(void);
+void flash_write_enable(void);
+void flash_write_disable(void);
+void flash_sector_erase(uint32_t address);
+void flash_block_32_erase(uint32_t address);
+void flash_block_64_erase(uint32_t address);
+void flash_release_powerdown(void);
+void flash_powerdown(void);
+void flash_read_manufacturer_device_id(uint8_t *device_id);
+void flash_read_jedec_id(uint8_t *jedec_id);
+void flash_read_unique_id(uint8_t *unique_id);
+void flash_read_status(uint8_t *status_reg);
+int flash_read_data(uint32_t address, uint8_t *dest_buf, size_t size);
+int flash_write_data(uint32_t address, uint8_t *data, size_t size);
+
+#endif