mirror of
https://github.com/tillitis/tillitis-key1.git
synced 2024-09-09 03:02:42 +00:00
34 lines
874 B
Markdown
34 lines
874 B
Markdown
![]() |
# CH552 USB-to-Serial firmware
|
||
|
|
||
|
## Toolchain setup
|
||
|
|
||
|
SDCC:
|
||
|
|
||
|
sudo apt install build-essential sdcc
|
||
|
|
||
|
CH554 SDK:
|
||
|
|
||
|
cd ~
|
||
|
git clone https://github.com/Blinkinlabs/ch554_sdcc.git
|
||
|
|
||
|
chprog (for flashing the firmware to a device):
|
||
|
|
||
|
cd ~
|
||
|
git clone https://github.com/ole00/chprog.git
|
||
|
cd chprog
|
||
|
./build.linux.sh
|
||
|
|
||
|
## Usage
|
||
|
|
||
|
Build the firmware using a default serial number:
|
||
|
|
||
|
make
|
||
|
|
||
|
Flash the firmware to a device:
|
||
|
|
||
|
make flash_patched
|
||
|
|
||
|
## Re-programming the firmware
|
||
|
|
||
|
By design, once the USB to serial firmware is loaded onto the chip, there isn't an intended way to reflash it using only software. However, if 3.3V is applied to the D+ line through a 10K resistor during power-up, then the CH552 will enter bootloader mode, and a new firmware can be programmed onto the chip. Note that the CH552 flash is only guaranteed for a few hundred flash cycles.
|