* Use receiver/transmitter models everywhere
* Run formatter
* Fix a copy-paste bug, make transmitter_model actually set tx_gain.
---------
Co-authored-by: kallanreed <kallanreed@outlook.com>
* Update spectrum_collector.cpp
lower case correction
* Update spectrum_collector.cpp
Description changed , better explanation.
* Revert "Update spectrum_collector.cpp"
This reverts commit 4a6fc35384.
* Revert "Update spectrum_collector.cpp"
This reverts commit 35cece1cb0.
* Revert "Solving Compile error on gcc10 . Keeping same safety protection about the size of the array ,but with slightly different sintax."
This reverts commit f4db4e2b53.
* Allow initial GAIN ,AMP changes after opened file
Current Replay App , shows in the user menu a UI to select two kind of controls for the RF output level :
1-) LNA GAIN (0..40 ) dB => but it has no TX effect because it is the RX-LNA . GAIN
2-) RF AMP (0 / +14dBm , (that was correct , we have two IC's , RX / TX ) (sw is controlling weill .
Note, although SW Version 1.40 do not leave to control drictly the GAIN TX
, that Replay App , in fact, it was using the inheritated selected GAIN TX from any previous usage of MIC App.
That Pull request alllows now to have the following controls
1-) GAIN TX (0..47 ) dB (now it is OK
2-) RF AMP (0 / +14dBm , (that was correct , we have two IC's , RX / TX ) (sw is controlling weill .
Remakrs : After the change , now we can control the GAIN TX , but not "in the fly" . When we are in the Replay loop , any change of the FREQUENCY or GAIN TX will be ignored , till we play STOP / START the loop again. (but the AMP RF (0 /+14 dBs) it works in the loop withouth any problems (same as before ) .
Re-enabled the tone key selector in Soundboard
Soundboard now uses OutputStream, like Replay
Constexpr'd a bunch of consts which were going to BSS section
Exiting an app now goes back to main menu
Cleaned up Message array
