AudioWizard
0
0
757
640
Audio Tuning Wizard
Introduction
Welcome to the RetroShare Audio Wizard
-
This is the audio tuning wizard for RetroShare. This will help you correctly set the input levels of your sound card, and also set the correct parameters for sound processing in Retroshare.
true
-
Qt::Vertical
20
291
Volume tuning
Tuning microphone hardware volume to optimal settings.
-
<p>Open your sound control panel and go to the recording settings. Make sure the microphone is selected as active input with maximum recording volume. If there's an option to enable a "Microphone boost" make sure it's checked. </p>
<p>Speak loudly, as when you are annoyed or excited. Decrease the volume in the sound control panel until the bar below stays as high as possible in the green and orange but not the red zone while you speak. </p>
true
-
Talk normally, and adjust the slider below so that the bar moves into green when you talk, and doesn't go into the orange zone.
true
-
1
32767
100
1000
Qt::Horizontal
-
Qt::Vertical
20
552
-
-
Stop looping echo for this wizard
-
Qt::Horizontal
40
20
-
Apply some high contrast optimizations for visually impaired users
Use high contrast graphics
Voice Activity Detection
Letting RetroShare figure out when you're talking and when you're silent.
-
This will help Retroshare figure out when you are talking. The first step is selecting which data value to use.
true
-
-
Push To Talk:
-
todo shortcut
-
64
64
-
Voice Detection
-
0
0
0
0
-
Next you need to adjust the following slider. The first few utterances you say should end up in the green area (definitive speech). While talking, you should stay inside the yellow (might be speech) and when you're not talking, everything should be in the red (definitively not speech).
true
-
1
32767
100
1000
Qt::Horizontal
-
1
32767
100
1000
Qt::Horizontal
-
Qt::Vertical
20
40
-
Continuous transmission
Finished
Enjoy using RetroShare
-
Congratulations. You should now be ready to enjoy a richer sound experience with Retroshare.
true
-
Qt::Vertical
20
267